Assembling Chair

Note: Your package includes parts to assemble two chairs. Repeat the steps below for each chair.

  1. Insert the seat into the first handle slot from the bottom on the back side of the traction board. Press until both sides lock securely into place.
  2. Insert the grooved end of each leg into the third handle slot from the bottom of the traction board. Ensure both legs are fully seated.
  3. Connect the two legs using the X-shaped support brace. Position the brace with the shorter side facing upward, then insert the tabs into the slots on each leg until fully seated.
  4. Verify that the seat, legs, and brace are securely attached before use.

Traction Chair Storage Instructions

Note: Two disassembled chairs can be stored inside one traction board.

  1. Remove the support brace, legs, and seat from the assembled chair.
  2. Position the two legs behind the seat panel with the grooved sides facing the seat. Align the legs with the seat and press them into the storage tabs until they lock into place.
  3. Place the X-shaped support brace horizontally across the center of the seat panel, between the two legs. Press the brace into the storage tabs until it is secured.
  4. Repeat Steps 2–3 for the second chair.
  5. Turn each stored chair assembly over and place one on each side of the traction board. Ensure all components are fully seated within the board for compact storage.